When placed in a “barrage” position in a duct, it ensures with a single device the filtering of the effluent, the removal and compacting of the waste materials, as well as their packing in plastic bags without the operator coming directly in contact with these products.
- Trough, transfer pipe and strain bars made of AISI 304 stainless steel
- Screw and transfer conveyor made of HR steel equipped with a Rilsan foot brush
- 308-400 V three-phase electric motor/drive
- Pressure diaphragm at outlet of compacting strainer
- Compacted block wetting ramp
- Vertical discharge hopper
- Pre-electric cabling
- Torque limiter
- Bagging unit
- Descent hopper
- Heat insulation and layout of the compacting area
- Assembly in caisson - channel
- Washing unit for degrating waste materials
- Pre-treatment industrial waste water
- Pre-treatment by stir-up reversal blower unit
- Pre-treatment for drain and flushing waste materials
|
Aquatec
300
|
Aquatec
400
|
Aquatec
500
|
|
| Conveyor screw diameter (Filtering/Transport) |
300/300
|
400/300
|
500/300
|
| Screw cross section |
100x15
|
150/10
100x15
|
200/10
100x15
|
| Electric motor/drive
power rating |
0,55
kw
|
0,75
kw
|
1,5
kw
|
| Wetting ramp flow rate |
95 l/min
|
95 l/min
|
95 l/min
|
| Filtering threshold (mm) |
Maximum
allowable flow rate (m3/h)*
|
||
|
1
|
55
|
150
|
220
|
|
2
|
70
|
180
|
270
|
|
3
|
80
|
205
|
310
|
|
4
|
95
|
235
|
395
|
|
5
|
110
|
270
|
440
|
The maximum flow rate is strongly affected by the nature and the concentration of the load.
Indicative information.
